They can email something like that but again - not much of a use on a stormy evening away from office with no internet access etc. Even if it can, I don't see such utility installed or on my install disk. I don't know if killing licence and getting kill number that could be used as licence on fresh install will work if application itself is corrupted by any means (bad HDD sector, infected by malware or else). This however at least allows me to defrag but it's real pain to backup and restore licence every time like this. Cannot run defragmenter anymore, must use floppy drive to move licence every time. (this is quite common for plants in rural areas). For example on weekend hardly anyone is in the office so no land lines, cell phone coverage is not good inside plant, and once you leave plant and door shuts, you are out for good or have no way to power the phone which drains battery very fast when signal is weak etc. Even if they did, working on site often means no reliable phone access. They also don't have 24/7 line to handle this and you get hosed if this happens on a weekend. Once i couldn't get anyone on the phone because it was holiday in USA (working day here in Canada).

Just call Mitsubishi, they are usually easy to communicate with. In my case it happened with GT Works and I'm still so mad about it.

They ware able to bring their laptop and help me finish the job. Well, it happened to me (twice) and fortunately in both cases we ware able to bring one of the customer's maintenance guys who didn't go fishing. Any help or suggestions greatly appreciated. Anyone else see this problem? I have spent about 3 hours on the phone working thru this on other computer and all they could suggest was to disable virus scanning of Melsec folder which we did on both computers.

This machine had to be running third shift tonight so thankfully its done. Lucky I was done with project as this being a holiday weekend I would have been screwed if this happened earlier. I later realized I needed to change a couple comments so I opened GX Developer and No License found. I had already made all program changes and saved everything to hard drive and USB drive. I was finishing up a 4 day project early this morning where I built a new panel and rewired a machine for future upgrades. Both times have to go thru deleting alot of things, calling with site code and getting new authorization. The engineer's laptop has lost license twice. We have 2 license, one on a engineer's laptop and another on a maintenance laptop. Hello, About 3 months ago we upgraded to GX Developer 8.

Gx works 2 serial key